I have a CJ6 that I’m wanting to sell. Had it for a year and I’m not going to be getting around to the rebuild project, so I’m looking to sell.

The Jeep is in the Kansas City area.  Some pictures are here, more details…

It definately needs a new tub. Runs and starts right up. Been sitting on a farmer’s field for about 5 years. I’ve had it for 1 yr sitting in my driveway. I start and let it get hot ~every 6 weeks. Have extras if wanted.
VIN: J4G845VE85488 (right hand drive)
Miles: 31k (Original?-see below)
Axles: D30/D44 (30-spline flange axle)
Ratio: 4.27’s
Engine: 232 I-6
Trans: 3-sp (probably T150)
T-case: Dana 20
Hubs: manual
Brakes, steering: drums, manual
New battery

It has 31k miles on odometer and this is probably correct. Engine has great compression as it holds the Jeep on my 23* driveway. I run gas from a 2.5 gallon tank on the floor and not the gas tank. Haven’t cleaned out the original tank. Did a flush of the oil and cooling system when I got it home. Never a leak at all, no where. No top, bad seats. Driver’s floor cut out (farmer did it). The VIN matches the rare right hand drive. Frame has steering box holes on left side if left hand drive is preferred. Frame is straight. Non-postal Jeep.

I have collected other parts over the year for it: 14-circuit wire harness (dash switch), fiberglass tub (un-cut), yr old Bestop/doors w/ frames, if interested. Wire harness was hard to find due to the non-column start switch. Pics in my webshots.

Located in Lenexa, KS (SW burb of Kansas City).
Mike ( )

CJ6 - $1200/bo
Tub- $600/bo
Wire harness - $350/bo
Soft top/doors - $500/bo

Please forward to who would be interested. Thanks.

Jagular7
Lenexa, KS

http://community.webshots.com/user/jagular7